Item information:
DC input: 30V 60Cells
AC output: 220V
Power: 230W
Smart grid tie microinverter with its own independent MPPT function, microinverter can be track down the best operating point of PV module at any time, and the MPPT efficiency more than or equal to 99%.
1. With SPLL(soft PLL) automatic power point locking technology, microinverter can be track down the max. power point of PV module and lock at any time.
2. MCU central processing design with independent chip operation for creating SPWM control signal, and run for soft start function.
3. Synchronous signal detection circuit design and high-frequency online grid-connected modulation for AC side, high-frequency synthesis and output sine-wave current which the frequency and phase are same as power grid.
4. With high-performance MOSFET, fast driving and higher performance.
5. Low voltage DC and isolation type booster circuit design for DC side leading to more safe and reliable for use and installation.
6. Anti-islanding setting auto detection, fast reaction, and more complies with grid-connected safe requirement of every countries.
7. With stacked in parallel using technology, microinverters will operate as a large power inverter at any time, more flexible for expansion of PV power system.
8. Fully Protection Functions: Input DC over/under voltage protection, anti-reverse connect protection, output AC over/under frequency protection and over/under voltage protection, short-circuit protection, overheating protection; IP65 waterproof function.
9. Communication operate through RF with data collector, and use with RS323/485 serial port communicate with computer for data collecting and remote monitoring.
Remark:
DC power sources refer to devices which output voltage are match microinverter input voltage setting range as 22-46VDC, included solar panels, batteries, wind generators which DC current operate through AC to DC controller.
AC power grid refer to single phase utility grid. Such as 110V(90-140V)and 220V(190-260V)single phase electrical utility service.
Parameter Table
DC/AC Steady Conversion Efficiency | >90% |
Recommend use solar panels | 36V/230Wp |
AC MAX output power | 230W |
DC maximum voltage | VpvDC46VDC |
DC input voltage range | Vpv 26V~46VDC |
DC Max. Input Current | 15A |
MAX output power factor | 98% |
DC input Reverse voltage protection | FUSE |
AC Output Power | 230W |
AC Max. Output Power | 230W |
MPPT Tracking Voltage Range | 24-46VDC |
MPPT Efficiency | >99% |
AC Standard Voltage | 110VAC)90V-140 or(220VAC)190~260VAC |
AC Frequency Range | 45Hz~53Hz/55Hz~63Hz |
THD at Rated power | THD <3% |
Phase | <1% |
Island Protection | Available |
Output Short-circuit Protection | Available |
Input Reverse Protection | Available |
Standby Power | <2W |
Night Powe | <1W |
Time for Starting upto Full Power | <3(Mins) |
Operation Temperature | -25 C~65C |
Operation Temperature Protection | >70 |
Waterproof Level | IP65 |
EMC | EN61000-6-3:2007 EN61000-6-1:2007 |
Grid disturbance | EN 50178+EN 62109-1+VDE0126-1-12 |
Grid detection | DIN VDE 1026 UL1741 |
1.Installation Instrallation:
1. Red terminal: Connect DC positive, black terminal: Connect DC negative. Shown in Figure 1.
2. AC socket: Connection to the mains. The AC cord to the inverter 3 foot outlet, then the AC cord to home
3PIN AC outlet. Are shown in Figure 2.
3. Switch: properly connected; turn on the switch, the inverter to work.
2. Application of Street lights:
Use this product, do not need to add a fan controller, solar panel controller, battery.
Connection Method 1
This connection method, wind energy, solar energy can supply to the grid at the same time, the highest efficiency.
3.Stackable connection (The purpose of small power inverter become high-power inverter)
In order to achieve higher power use requirements, the use of this product can be stacked, such as: 4 grid inverter 300W of stack used is equal to 1200W, and the number of open stacks(No Quantitative Restrictions).
Used as shown in Figure 2
LED indicator
1. Red LED indicator lights up under any conditions as listed below:
a. Low-voltage protection(DC input voltage lower than Min. input voltage of inverters )
b. Over-voltage protection(DC input voltage higher than Max. input voltage of inverters)
c. Over-temperature protection (inverters will be shut down for power output when the temperature of body of inverters higher than 65-75.)
And inverter will be automatically restart up when the temperature of body of the inverter down to 40-50.
d. Power grid fault protection (when 110VAC or 220VAC grid power outage and/or tripped.
e. Islanding protection: inverter will be automatically shut down for power output when disconnect with power grid.
Specifications | |
Input Voltage | 36V |
Output Voltage | 110V |
Output Power | 230W |
Output Current | 15A |
MPPT Tracking Function waterproof 230W 110V Solar panel on Grid System Micro Inverter 36v mc4 solar pv connector
- Brand: Inverter Expert
- Product Code: waterproof 230W 110V
- Availability: In Stock
-
$98.92
Related Products
MPPT Tracking Function waterproof 230W 110V Solar panel on Grid System Micro Inverter 24v mc4 solar pv connector
Item information:DC input: 30V 60CellsAC output: 110VPower: 230WSmart grid tie microinverter with it..
$98.92
MPPT Tracking Function waterproof 300W 220V Solar panel on Grid System Micro Inverter mc4 solar pv connector
Item information:DC input: 30V 60CellsAC output: 220VPower: 300WSmart grid tie microinverter with it..
$98.92
MPPT Tracking Function waterproof 230W 220V Solar panel on Grid System Micro Inverter 36v mc4 solar pv connector
Item information:DC input: 30V 60CellsAC output: 220VPower: 230WSmart grid tie microinverter with it..
$98.92